or typical work breakdown and easy to repair in our blind is spring break picker. There are many different models of collectors, but almost all follow the same principle of operation.
Symptoms: The tape is loose and low single shade, or just does not pick up the tape.
Sometimes the solution is to give a little more tension the spring, but in most cases will be replaced.
In the picture you can see a model of the most common and major parts:
1 - spring or spring which can be metal or plastic wrap but for that matter.
2 - screw tape. In some models is a screw in others, as in the photo, is a pin fixed in any case before putting the tape should be prepared in the same cut to hold it.
This cut is about two inches from the tip of the tape and will have an inch long so that the cut is passed by the bolt head or stud and tighten a little tape is attached.
3 - braking mechanism is a metal that causes the tape to "step" and so the shade does not go down alone and is part of the support-spring so that deserves more explanation.
Before attaching the tape to the collector must follow two important steps:
1 - Thread the ribbon through the brake checking that no returns or is forced and put in a position to secure the dock, we see that is easily attached but we do not yet.
2 - firmly taking the whole tape and almost ready we turn the spring to give the maximum voltage possible (in a sense takes voltage and another does not depend on model) and when to keep the tape taut.
Care should be taken because if we miss the spring we can do damage in the hand, so calm and hold on tight.
And i am just hold the assembly to the wall with its corresponding screws (usually 2) and trim if I had.
Symptoms: The tape is loose and low single shade, or just does not pick up the tape.
Sometimes the solution is to give a little more tension the spring, but in most cases will be replaced.
In the picture you can see a model of the most common and major parts:
1 - spring or spring which can be metal or plastic wrap but for that matter.
2 - screw tape. In some models is a screw in others, as in the photo, is a pin fixed in any case before putting the tape should be prepared in the same cut to hold it.
This cut is about two inches from the tip of the tape and will have an inch long so that the cut is passed by the bolt head or stud and tighten a little tape is attached.
3 - braking mechanism is a metal that causes the tape to "step" and so the shade does not go down alone and is part of the support-spring so that deserves more explanation.
Before attaching the tape to the collector must follow two important steps:
1 - Thread the ribbon through the brake checking that no returns or is forced and put in a position to secure the dock, we see that is easily attached but we do not yet.
2 - firmly taking the whole tape and almost ready we turn the spring to give the maximum voltage possible (in a sense takes voltage and another does not depend on model) and when to keep the tape taut.
Care should be taken because if we miss the spring we can do damage in the hand, so calm and hold on tight.
And i am just hold the assembly to the wall with its corresponding screws (usually 2) and trim if I had.
0 comments:
Post a Comment