m Ontar or replace a faucet on a sink is straightforward, we just need to understand how it is mounted and have some skill as with the sink mounted almost becomes a contortion exercise because you have to work from the bottom and little room to handle the tools, but with determination and patience can get. Whether a
Ordinary tap or a mono-command the wearing varies little. We
tap itself which is what we see when we look at the sink, are screwed on this water hoses (No. 3 in the picture) to be put before the assembly.
fitted with hoses passed these through the hole of the cabinet taking care to put the rubber seal that goes between the tap and the sink and now we work from the bottom.
The lower part is seen in the image and assembly order is placed: a board of plastic, then the washer plate (# 1 in picture) - it has a special horseshoe for mounting with ease, and screws and nuts (No. 2) that tap according to the model will be one or two.
hand was tightened these nuts to leave the group presented on their site and check that the rubber seals are well in place and you can go and tighten with a wrench (a socket wrench is ideal) by ensuring that the tap is focused. With the tap
subject in its final position and is just connect the hoses to the water supply we will have on the wall for their own position must be the cold water on the right and the left hot but if perhaps we checked before the connection.
The work itself is simple, just take into account some details before starting to avoid complications following: 1 º check
we have the right tools, it may appear that we manage somehow with some pliers, but then we go crazy.
2 º verify that the length and diameter of the hose is enough, lest we need any extension or adapter and caught us with closed hardware. 3 º
be clear where the water is cut and isolation taps for the site where we will work and take advantage of whether to repair or replace any.
Ordinary tap or a mono-command the wearing varies little. We
tap itself which is what we see when we look at the sink, are screwed on this water hoses (No. 3 in the picture) to be put before the assembly.
fitted with hoses passed these through the hole of the cabinet taking care to put the rubber seal that goes between the tap and the sink and now we work from the bottom.
The lower part is seen in the image and assembly order is placed: a board of plastic, then the washer plate (# 1 in picture) - it has a special horseshoe for mounting with ease, and screws and nuts (No. 2) that tap according to the model will be one or two.
hand was tightened these nuts to leave the group presented on their site and check that the rubber seals are well in place and you can go and tighten with a wrench (a socket wrench is ideal) by ensuring that the tap is focused. With the tap
subject in its final position and is just connect the hoses to the water supply we will have on the wall for their own position must be the cold water on the right and the left hot but if perhaps we checked before the connection.
The work itself is simple, just take into account some details before starting to avoid complications following: 1 º check
we have the right tools, it may appear that we manage somehow with some pliers, but then we go crazy.
2 º verify that the length and diameter of the hose is enough, lest we need any extension or adapter and caught us with closed hardware. 3 º
be clear where the water is cut and isolation taps for the site where we will work and take advantage of whether to repair or replace any.
0 comments:
Post a Comment