Buy Michael Vick Cleats

problem in washing machine water fill

O ORT common problem in the washing machine is not filled with water, water flows from the top or just sits there, like looking at us, with the pilot on and doing nothing.

The person responsible for this failure is the combination of by the solenoid valve and pressure switch, the first more than the second, and that is exposed to greater wear and debris out of the hard water.

As a continuation of my articles where I explained the problems with spin and the water pump I will try to solve these mechanisms are also occasionally break

explain its operation under scheme have drawn with more or less success, once we understand will be easier to determine the fault.

- The solenoid mission is to allow the passage of water into the machine at each moment, according to the developer and he says using the switch.

is located right at the entrance where you plug the hose. When you turn the machine opens and lets the water, one part goes to the box of detergent and drag this to the drum, a series of mechanisms put into the water outlet situation with the corresponding drawer (detergent, fabric softener ... ) and another part goes directly to the drum.

So here are two possible faults: 1 if the valve is opened (either because no power, because it is clogged with dirt or it is broken) simply does nothing for washing machine should not run until you have a level minimum of water. This level is marked by the switch. Y 2 º if the soap drawer is stuck (Is most cases) or the mechanism that directs the flow of water is broken we will overflow the water by detergents.

Solution

clean or replace the valve box or

appropriate

, "The pressure is to send mission to close the valve when the water level is optimal and to prevent the washer otherwise. It consists of a switch actuated by the relative pressure that comes from the drum through a rubber tube (how much water there is more pressure but it comes to closing the circuit), if you damage or lose air through the tube simply machine not working or not will stop filling with water. Switch faults are rather rare but do occur. Solution

replace the pressure switch and tubing.

own experience is more common fault in the solenoid. I explain
operation is basic to understand, then things get complicated a bit more with electronics and the programmer, but it serves to resolve almost all models of machine that I know and remember that I am not a technician, just a handyman with experience and desire to share.